Coinco BA30B Bill Validator Acceptor

Coinco BA30B dollar bill acceptor / validator can accept $1's. It is one of the most dependable and reliable validators on the market. Has a dual interface, single price or multi-price and can run on 110V or 24V MDB. Trouble Shooting Coinco BA30B bill validator not accepting Coinco BA30B bill acceptor wont accept First thing to do when trouble shooting this bill validator is to check the flash codes on the back of the remote box on the side of the validator. If the light is solid red the validator thinks its working properly. The following is the Diagnostic error codes for this unit. # Of Flashes Description of Flash Code 1 Bill Box Full 2 Bill Box Lid is Open or Bill box is Off** 3 Check Bill Path 4 All Bill Accept Switches are Off 5 Bill Jam or Sensor Error 6 Stacker Motor/Home sensor 7 Transport Motor/Encoder Sensor 8 (Reserved for future use) 9 EEPROM Check Sum error 10 RAM or ROM Check Sum Error 11 Center Optic Sensor 12 Right Optic Sensor 13 Left Optic Sensor 14 Bill Position Sensor Error* 15 Right Position Sensor 16 Left Position Sensor 17 Lower Board Anti-Pullback Level Sensor 18 Upper Board Anti-Pullback Lever Sensor* When trying to fix a non working bill acceptor. Start by taking the bill box off and the bottom deck out. Then blow out the entire unit with an air compressor. Then clean the sensors with a damp cloth. There are two sets of sensors one on the bottom deck you removed and one set inside the deck housing on the upper side.